END POINT SECURITY - ACCESS POLICIES
Passive mode
If enabled, any rules added to the list will always be allowed to execute.
Enable rule logging
If enabled, the administrator can retrieve information about the rules that have been running from the TDA logs file.
Startup Rule Group
If enabled, the rule created inside this group will run when the TDA session starts.
Repeat Rule Group
If enabled, the rule created inside this group will run inside the TDA session every X minutes.
Please refer to the Knowledge Base article for more info.
END POINT SECURITY - ACCESS POLICIES RULE GROUPS
END POINT SECURITY - WINDOWS UPDATE SETTINGS
Only updates older than
If enabled and “Close TDA” is selected, users must install only available updates older than the specified days, or they will not be able to use Secure Remote Worker. If enabled, and “Allow to Continue” is selected, the user can launch TDA.
Only definition updates older than
If enabled and “Close TDA” is selected, users must install only available definition updates older than the specified days, or they won’t be able to use TDA. If enabled, and “Allow to Continue” is selected, the user can launch TDA.
Ignore the following updates
If enabled, all the updates specified in the list will be ignored.
Note: A manual check will be necessary if an update is added to the list.
Only include the following updates
If enabled, only specific updates in the list will need to be installed.
Ignore 3rd party driver updates
If enabled, all the 3rd party drivers’ updates will be ignored.
END POINT SECURITY - NETWORK
Perform Download test
If enabled, the download test against the Hostname section will be performed for X seconds.
Perform Upload test
If enabled, the upload test against the Hostname section will be performed for X seconds.
Hostname
The URL address where the test will be run against.
Perform TCP Ping
If enabled, the TDA will verify network connectivity against that specific hostname and port number.